Soft-Serve Ice Cream Craft

The whole Beginner level is free. Intermediate and Professional unlock for a one-time $29 each.

Sign up free
Lesson 3 of 7

Machine Setup: Hopper, Cylinder and Hardness

Machine Setup: Hopper, Cylinder and Hardness

⏱ About 2 min read

⚡ In 30 seconds

  • Food-grade lubricant on every seal and O-ring
  • Prime until air stops bubbling, then freeze
  • Hopper stays ≤4 °C and never runs dry
  • Adjust hardness one step at a time
  • Use standby mode in quiet periods

Assembly: lubricate O-rings and seals with food-grade lubricant only, fit the beater and front door, tighten door knobs evenly in a diagonal pattern to prevent leaks.

Priming: pour mix into the hopper, open the air tube or feed valve and let mix fill the cylinder until air stops bubbling out. Then start the freeze cycle.

Hopper: keeps mix at or below 4 °C. Never let it run empty while freezing — the cylinder can freeze solid and damage the beater.

Hardness / viscosity: most machines measure motor load and stop freezing when the product reaches a set hardness. Start at the manufacturer default (often 6–8 on a 1–10 scale) and adjust one step at a time. Too soft = slumping swirl; too hard = freeze-ups and motor strain.

Standby or keep-fresh mode holds mix cold overnight without freezing — use it during quiet hours instead of switching off.

Watch Real Barista Demonstration

🏪 Real Café Scenario

The machine kept tripping in the afternoon heat. The hardness had been pushed to 10 for a 'firmer swirl'. Back at 7, it ran all day.

Try this today

Listen to the compressor. Constant running in a slow hour usually means low mix, a leak or a hardness set too high.

Previous