Soft-Serve Ice Cream Craft

The whole Beginner level is free. Intermediate and Professional unlock for a one-time $29 each.

Sign up free
Lesson 7 of 7

Troubleshooting Common Problems

Troubleshooting Common Problems

⏱ About 2 min read

⚡ In 30 seconds

  • Runny: check hardness, recovery time, mix temperature
  • Freeze-up: low mix or hardness too high
  • Icy: product sat too long — draw it off
  • Leaks: worn or dry seals
  • Off taste: cleaning or old mix

Too soft / runny: hardness set too low, machine not caught up after a rush, warm mix poured in, or air tube blocked. Give it recovery time and check the setting.

Too hard / freeze-up: hardness too high, low mix level, or the machine left freezing without dispensing. Switch to standby, let it thaw slightly, top up mix.

Icy or grainy: product sat too long in the cylinder, poor powder hydration, or mix refrozen. Draw off old product and serve fresh.

Leaking at the door: worn or dry seals, door knobs uneven. Replace seals on schedule and re-lube.

Off taste: old mix, poor cleaning, or mix absorbing fridge smells. Clean fully and store mix sealed.

Keep a laminated fault chart near the machine so any team member can fix the basics.

🏪 Real Café Scenario

During a heatwave the swirl went runny every 20 minutes. Spacing out orders slightly and keeping the hopper full let the cylinder recover.

Try this today

Change seals and O-rings on a schedule, not when they fail. They are cheap; a lost Saturday is not.

Previous