The whole Beginner level is free. Intermediate and Professional unlock for a one-time $29 each.
Sign up free
⏱ About 2 min read
Set up: cold milk (straight from the fridge) in a clean pitcher, filled to just below where the spout starts.
1. Purge the wand into the drip tray. 2. Place the tip just below the milk surface, slightly off-centre. 3. Turn the steam fully on. 4. Stretch (add air): keep the tip near the surface so you hear a soft, steady "tss-tss" like paper tearing. Do this only until the pitcher feels lukewarm — about 2–4 seconds for a latte, a little longer for a cappuccino. 5. Texture (spin): raise the pitcher slightly so the tip sinks and the milk spins in a whirlpool. This mixes the foam in. 6. Stop at 55–65 °C — when the pitcher is too hot to hold comfortably for more than a second. Turn the steam off before pulling the wand out. 7. Wipe and purge the wand straight away. 8. Tap and swirl the pitcher: one tap on the counter to pop big bubbles, then swirl until the milk looks shiny like wet paint.
Foam guide: flat white — very thin foam; latte — about 1 cm; cappuccino — 1.5–2 cm.
Plant milks: steam a little cooler (about 55 °C) and stretch gently; oat is the easiest, almond and soy split if overheated.
0 of 6 steps done
Gauge
Good: Needle steady in the green zone
Problem: Needle swinging or out of range
Group head
Good: Even water flow on flush
Problem: Spitting, dripping or water leaking around the gasket
Steam
Good: Dry, powerful steam after purge
Problem: Weak or very wet steam
Sound
Good: Pump hums only while brewing
Problem: Grinding, rattling or a pump that won't stop
A barista's cappuccinos came out with big, stiff bubbles. She was stretching all the way through. Stopping the air once the pitcher felt lukewarm gave her silky foam the same day.
Hold the pitcher by the handle with your other hand flat on its side. Your palm is your thermometer — once it's too hot to hold, you're there.