Manual & Filter Brewing

The whole Beginner level is free. Intermediate and Professional unlock for a one-time $29 each.

Sign up free
Lesson 1 of 7SCA · Brewing · Intermediate

Brew Ratio, Strength and Extraction for Filter

⏱ About 2 min read

⚡ In 30 seconds

  • Start filter at 1:15–1:17 (e.g. 15 g : 250 g)
  • Strength = how concentrated; extraction = how much was dissolved
  • Typical filter strength is about 1.15–1.45% TDS
  • Ratio adjusts strength; grind and time adjust extraction
  • Sour and thin = under-extracted; bitter and dry = over-extracted

Filter coffee runs on the same physics as espresso, just slower and with far more water.

Brew ratio is coffee to water by weight. Most cafés sit between 1:15 and 1:17 — 15 g of coffee to 250 g of water is a good everyday starting point.

Strength is how concentrated the cup is, measured as TDS (total dissolved solids). A typical filter lands around 1.15–1.45% TDS. Too low tastes watery; too high tastes heavy and muddy.

Extraction is how much of the coffee you dissolved, ideally around 18–22%. Under-extracted filter is sour, thin and short. Over-extracted filter is bitter, dry and hollow.

The key idea: ratio mainly moves strength, grind and contact time mainly move extraction. If a cup is weak but tastes balanced, change the ratio. If it is sour or bitter, change the grind first.

Watch Real Barista Demonstration

🏪 Real Café Scenario

A guest says your filter is "weak but nice". The flavour is balanced, so you keep the grind and move from 1:17 to 1:15. Same coffee, more body, and the guest is happy.

Try this today

Always weigh water, not volume. A kettle marked in millilitres is fine at home, but on bar you want the scale doing the work.